Vibration Viscometer SV-1A

Viscosity Viscometer measures the viscosity of the electrical current detection, required to resonate the sensing plates at a constant frequency of 30 Hz and amplitude less than 1 mm. The required amount of a sample is 2 ml. The measuring range is 0.3 mPa · s to 1000 mPa · s. Repeatability of measurement 1%, possibility of sample temperature arrangement.

  • new vibration method enables high precision and wide range of measurements without the necessity of changing the sensing parts! The SV series vibration viscometer measures the viscosity by determining the excitation current value required for the resonance of two sensing parts at a constant frequency of 30 Hz and an amplitude of less than 1 mm
  • real-time measurement
  • temperature measurement
  • continuous measurement
  • viscosity calibration
  • simple single point or two-point calibration
  • measurement of non-Newtonian liquids. Thin sensing plates cause only minimal change in sample structure, allowing stable viscosity values ​​to be measured
  • measuring of foam and foaming samples
  • Measuring liquid samples. It is possible to measure the viscosity of liquid samples, including liquids in a turbulent flow
  • small amount of measured sample. Just about 35 ml of a sample (2 ml for SV-1A) is sufficient for measurement
  • Easy to clean
  • Measure colloidal solutions and gels. E.g., starches can be measured during of the characteristics changes
  • RS-232C interface
  • Data acquisition and graphics software. WinCT-Viscosity (RsVisco) is software designed for transmitting measured viscosity and temperature data to your PC and graphically displaying real-time changes for analysis